Requisite Audio Engineering L2M MKIII M/S VERSION Manual del operador descargar pdf (Pagina 14)

FRONT PANEL CALIBRATION POINTS (continued)

VU ADJ

VU ADJUST is for calibration of VU only. It does not affect GAIN REDUCTION readings.

VU ADJ - CALIBRATION PROCEDURE:

•

Set PEAK REDUCTION & LIMITER RESPONSE fully-counterclockwise.

•

Set OUTPUT LEVEL, LIMITER FEEDBACK & STEREO LEVEL RIDE to UNITY.

•

Set IN/BYPASS to BYPASS

•

Allow 10 minutes system warm-up time and 1 minute rest from any peak reduction activity.

•

Inject a +10dBu (2.45V) 1-kHz tone (both channels). Verify level using an external DMM or

suitable meter. If your DMM has a dB function, select that. If not, set to A/C and read

2.45VAC across pins 2&3 of the OUTPUT XLR.

•

Set IN/BYPASS to IN

•

Select +10 on the METER SELECT and observe if the VU METER reads 0dB.

•

Adjust as necessary.

•

+4dBu is factory set to follow the +10dBu calibration. After the above calibration is com-

pleted, the VU METER should read 0dBu when METER SELECT is set to +4 and a 1-kHz tone

of .775v is applied to the input.

STEREO ADJ

STEREO ADJUST (2 each) - In order to achieve proper stereo or multi-channel gain re-

duction action, each channel should be adjusted to be equal. Carefully read the STE-

REO ADJUST calibration procedure to be sure you have a thorough understanding be-

fore attempting calibration. The L2M is fully calibrated for stereo operation before leav-

ing our shop.

THE L2M MKIII M/S VERSION

R e q u i s i t e A u d i o E n g i n e e r i n g! L2M MkIII

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Sin comentarios

Requisite Audio Engineering L2M MKIII M/S VERSION Manual del operador Pagina 14